What are the characteristics of 6008 / HR11TN non-standard bearing

What are the characteristics of 6008 / HR11TN non-standard bearing source: bearing | last updated: - 2020 06 - 11 6008 / HR11TN non-standard bearing what are the characteristics of non-standard bearings and what are the similarities and differences between the angular contact ball bearing? Inner and outer diameter and width the same non-standard bearing and angular contact ball bearing inner ring is the same size and structure, and the outer ring size and structure of different: 1. Non-standard bearing outer ring grooves on both sides of the shoulder, his shoulders and angular contact ball bearing is usually one shoulder; 2. Non-standard curvature is different from the angular contact ball bearing outer ring groove, and the latter is usually bigger than the former; 3. Non-standard bearing outer ring groove position and angular contact ball bearings are different. The center position, and what should be considered in the design of angular contact ball bearing of a specific value, and is related to the size of the contact Angle; In terms of use: 1. Two applications are different. Non-standard bearing is suitable for bearing radial force, axial force of the smaller, axial-radial joint load and torque load, and the angular contact ball bearings can withstand a single radial load, large axial load, According to the different contact Angle change) Pairs ( Along with the matching methods vary) Can be subject to bi-directional load and torque load. 2. Different speed limit. The same size of angular contact ball bearing limit rotational speed is higher than the limit speed of non-standard bearings. How to adjust safely non-standard bearings? What steps need to be performed? 1. Two-way deviation must be run in a direction adjustment before you, and then adjust the other direction. Please note, when adjustment, must observe carefully belt running direction and the relationship between the deviation trend, and one by one to adjust. Remind users: must focus on on the regulation of drive roll and reverse roll, in order to avoid divergence in two-way operation. Second, tensioning unit weight two directional control of the upper roller tension components should be perpendicular to the length of the belt or perpendicular to the vertical line of gravity. When using screw tension or hydraulic cylinder, two of the tensioning roller bearing need translation at the same time, to ensure that the roller's axis is perpendicular to the vertical belt. 3. Carrying idler wheel manufacturing, idler wheel must grow up will be installed on both sides of the hole drilling hole, and make an adjustment. Methods: when run non-standard bearings, which side of the belt is bias, which side will be in the belt idler wheel direction or the other direction to move forward. “