Spindle center water swivel installation considerations

Spindle center water swivel installation considerations - 2019 05 - 6 in order to ensure that bell ( BEIER） The maximum service life and reliability of the rotating joint, the installation engineers need to comply with the following simple steps to operation. Step one lock coupling on the rotary joint rotating joint is fixed on the vise, then pipe joint tangle on seepage belt, with wrench lock as shown in figure 1. Step 2 locked bell rotary joints in tie rod end joint and tie rod end face clean, there shall be no burrs and dust and other foreign matter, to ensure that the deflection of seepage effect after locking and normal as shown in figure 2. Step three lock high pressure pipe on the pipe joint use two open end wrench, a fixed pipe joint, a lock high pressure pipe, avoid make rotary joints under influence and damage, the high pressure pipe should guide is to stents, stent is close to the rotating joint in order to avoid stress when the swivel up and down, keep rotating joint influence or bending force (under High pressure water can make the pipe harden) To ensure that rotary joint life as shown in figure 3. Rotary joint using Suggestions in order to ensure that rotary joint use of longer life, center water supply, the spindle should turn to water supply, first stop, the water first, then stop the spindle. Cutting fluid according to the specification of rotary joints require blocking, and replaced periodically cutting fluid to avoid deterioration ( Thick) Keep the lubricity of cutting fluid. Note: the handle tool if there is no hole, should avoid the wrong with the center water supply ( Gas) In order to avoid rotary joint shaft seal bearing damage. （ Source: bell rotary joint)