Small bearings: since embellish bearing what material

As bearing heating temperature is ° C ~ ° C, the bearing heater, heater, induction puller, gear ring heater is the principle of induction heating for production. GB— — Face to face, back to back arrangement, bearing with medium of pre-load, GC - — Inside the face to face, back to back arrangement, bearing a heavy load. Remove the tire to open the dustproof cover dust cover remove to avoid to use brute force, it is prohibited to use hammer percussion, dust cover deformation or damage, will lead to driving bearing into the water. Problems of irregular different sound: cleaning related parts, the use of clean and grease; Clearance is too large, pay attention to the coordination and choose appropriate clearance; Scar of steel ball, steel ball fatigue spalling or injury, replace the bearing. The next step of the repair work is very simple, the second half of the bearing in vitro round with a radial adjusting pad, the upper bearing a radial adjusting pad at the top, for bearing adjustment. Keep reasonable lubrication should be: correct lubrication and maintenance is critical, correct installation and use is also indispensable, to make full use of existing equipment condition monitoring. Figure - for vortex spray high-pressure rotor shaft coupling, rigid coupling, it belongs to the set of tooth with arc end tooth mass torsion, centering ( Including work centering) The bolt axial force. Figure the inner diameter of the gasket surface figure breaking gasket fracture morphology of the hardness testing the hardness of bearing pads in the HR - A determination of rockwell hardness tester, load for kg range of error of plus or minus. Low at the top of the tank manhole cover plate should cover tightly, do not open, the bearing, and bearing inner ring and shaft relative sliding, bearing inner ring and the shaft with the neck is not tight. Be butter cover of ABS sensor probe smudgy probe has not see like many ABS sensor fault cases are caused by bearing too much butter, too much of the butter when installing wheel is easy to be pushed to the probe. Cylindrical hole bearing, multi-purpose press press into, or use hot charging method, this approach is limited to use surplus quantity is small, cannot be applied to large amount of interference, or medium and large bearing. The cause of rolling bearing rust corrosion failure a lot, mainly include: water, corrosive substances ( Paint, gas, etc. ) , lubricant is not appropriate, due to the condensation of water vapor with drops of water, high temperature more stalling when wet, rust bad transportation process, takes care of the state is not appropriate, improper use, etc.