Sliding bearing installation method and matters needing attention

One of the most common type of bearing - Sliding bearing, has an important in industrial machinery and equipment spare parts, so we in the sliding bearing of installation must carry on the correct installation method, or cause to carry on the good operation of the sliding bearing even cause accidents to the mechanical equipment. China bearing network, according to the experience knowledge sharing about the installation method of sliding bearing and matters needing attention. Sliding bearing installation method: 1, keeping components of sliding bearing, bearing and shaft are located in different position of the axial sliding department working procedure; With the sliding bearing 2, the abutment pressure in the same shaft diameter fine processing rod inserted into the sliding bearing of the bearing hole working procedure; 3, in the bearing hole insert have a great state, sizing processing push radial sliding bearing axial sliding part of the peripheral processes. Sliding bearing installation note: 1, seat hole design for easy deformation of materials such as aluminum alloy or a hole wall thickness is thin, please make this clear, to make a hole deformation in order to avoid being connected. 2, in order to make the assembly easier and won't destroy wear-resisting layer, axial end face must have a chamfer, smooth shaft material Suggestions for bearing steel surface hardening treatment hrc45, surface roughness for rz2 - 3, the surface can also be hard chrome plating. 3, before assembly shall ensure that no foreign body, shaft sleeve, seat hole surface pore surface should be bright and clean as far as possible in order to avoid scratch during assembly. 4, the assembly can be outside the shaft sleeve surface coated with appropriate lubricating oil, help the shaft sleeve is convenient to install, but not too much to avoid the overloading or when the reciprocating motion shaft sleeve will be out. 5, with core shaft assembly should be slowly pushed ( It is recommended to use hydraulic press) Tapping shaft sleeve, a ban on direct to avoid the distortion. 6, the assembly there is possible, please in the shaft surface coated with grease to shorten the sleeves running-in period. 【 Warm prompt. 【 The bearing network] Some information from the Internet, and strive to secure timely, accurate, aims to deliver more information, does not represent our views to its approval or responsibility for their authenticity. If this net reprint information involves the issues such as copyright, please contact with this net. Tel: 0571 - 81630205. Tags: install and remove