SKF bearing oil film smooth change detailed steps

Smooth management of the oil film SKF bearing oil is very important, should not be ignored, and detailed introduced as follows: the main reason of mechanical problem or early wear, more than half of them are related to the smooth and technical management. Smooth management well, to avoid the SKF bearing, gear friction in the moving parts, such as scratches or sintering, avoid and reduce the wear and tear, reduce the friction resistance, prevent the onset of equipment accident, advance equipment consumption efficiency; Progress to save energy, energy efficient utility ratio, increasing economic benefit, is the main task of the smooth management work. 1, smooth management is a professional and technical management, should establish professional technical management personnel, smooth smooth management system, smooth stop technology knowledge training. 2, under the precondition of reasonable fuel tank capacity, adhere to the reasonable tank oil level, often to the oil tank fill smooth, make the oil tank of oil has been in a reasonable operation, the oil degassing, precipitation machine noise, separation of water and reduce the oil temperature in the cabinet are favorable. 3, timing, positioning extract + sample in the line, from product flavor, color, viscosity change, performance, pollutant category and water content, water content, anti-foam performance stopped testing laboratory, etc. Enter the smooth water content in oil of beyond zero. Sharply increased 1%, the mechanical wear and tear; Beyond zero. The smoothness of the 5% it will be a risk. Prepare test records. 4, analyze the match each inspection records, prediction to stop the bad smooth forecast, work out improvement or measures are avoided. On the system of the oil level, oil, oil temperature, oil pressure alarm and interlock control to secure peace, smooth eradicate the attack of the accident. Will now walking steel wheel SKF bearing place when changing the oil seal oil seal leakage, the detailed steps of 1, loosen the vibration motor four fixed bolt, and unload the vibration motor ( Don't have to remove the hose on the motor) ; 2, loosen the motor seat seven fixed bolt, and detach the motor seat; 3, loosen the supporting plate, and walking on eight of the retaining bolt bearing and bearing plate and frame before connecting bolt, unload the bearing plate along with shock absorbers, support; 4, loosen the SKF bearing damper on eight of the retaining bolt, and unload the baffle; 5, looking for a diameter less than the plate of SKF bearing inner ring, bearing shaft head outside the mat; 6, the left end cap will be removed, the back cushion on the plate, looking for the 7 M12 x 70 bolt, used for fastening walking left end cover and bearing seat; 7, according to the diagonal phase locking in turn seven bolts in this picture, you can pull the bearing seat and SKF bearing as walking, walking the bearing rotating flat, can change models for phi 180 x 220 x 18 skeleton oil seal. Device when the note according to the disassembly time of each part antitone stop device. In the skeleton oil seal and drive on bearing and the bearing seat outside all needs to add more butter, so as to avoid damage to the oil seal when pressed, cause oil leakage problem again.