SKF bearing installation can affect life and performance

Bearing installation is a university asked, whether you installed is very good quality bearings or quality comparison of domestic bearing, may affect the bearing's life and properties, so we need a measured at the time of installation of SKF bearing installation, if you don't understand the installation technology of bearing don't blind to install, they know there is no relationship. Bearing is one of the important parts on construction machinery, poor installation will affect its use effect, even result in engineering machinery and equipment failure. If SKF bearing with iron filings, burr, dust and other foreign matter to enter, will make the SKF bearing noise and vibration during operation, and even damage raceway and rolling body. So, before the installation of SKF bearing, must ensure that the installation surface and the environment clean. Bearing installed after, if not done carefully alignment, alignment can lead to bearing suffered another load, friction, and vibration. The use of these may accelerate fatigue and reduce the bearing life, and it might damage the other machine parts service life. In addition, the increase of vibration and friction could significantly increase the risk of energy consumption and premature failure. Attaches great importance to the bearing replacement new fat work by Yu Run fat varieties, quality is in constant improvement and change, the old equipment to switch to a new SKF grease, should look after the test, trial rear can officially use; When change the new fat, should first remove waste SKF grease, clean parts clean. When adding SKF grease, waste should be fat extrusion, when fat mouth see new grease. Auto bearing the use of maintenance bearing maintenance state inspection: the removal of the bearing with kerosene or clean gasoline, observe carefully if there is a sliding or bearing inner and outer cylinder creep phenomenon, inner and outer race of bearing surface spalling, pitting, rolling element and cage for wear and deformation, etc. , according to the comprehensive situation of bearing inspection, to determine whether a bearing can continue to use.