S700K electric switch machine fill site emergency treatment method

S700K electric switch machine fill site emergency treatment method - 2021 02 - The on-site emergency measures: first drainage: 1. First, pull out the drain plug at the bottom of the switch machine, eliminate water accumulation in the machine; 2. With water washing machine motor gear, screw, retainer, action bar, locking lever block and detection, and then use gasoline ( Kerosene, diesel oil) Again cleaning, reoccupy dishcloth, also canned air cleaning are available, and ultimately to ensure that no water damage; 3. Contact sludge, first with water cleaner, and blow dry, to ensure no water damage; 4. Decomposition of motor to eliminate water accumulation in the motor and blower, special canned air cleaning and assembly; 5. Clear water transmission parts, bearing sludge and stasis ( Including bearings on both ends of the screw, the flange hole section) Here need special canned air cleaning. After maintenance: 1. In removing the motor gear, screw, retainer, action bar, and testing of the pole, surface dirt and rust, the rust parts and screw parts clear with more than 20 clean lubricating oil; 2. Lock tongue, locking blocks used a large amount of kerosene ( Diesel, petrol) Clear water, prevent rust card resistance; 3. After cleaned up the water damage of retainer, on the surface of the control panel that retainer evenly coated with more than 20 clean lubricating oil; 4. After confirm the roller screw without water, roller screw nut on both ends of the threaded portion with special grease; 5. Motor gear set, especially on both ends of the wheel bearing, should be more than 20, clean the oil injection, large gear and motor friction coupling surface should be evenly coated with railway 2 lithium base grease; 6. Easy to rust parts inside the machine basting. Note: 1. On both ends of the roller screw nut and screw bearing by the grains of sand to remove inside, there is no guarantee that when using not fail; 2. Motor reliable because there is no guarantee that the water its insulation, bearing a rust, jam and other unpredictable conditions; 3. TS - 1 contact may be used dry cleaning, but attention should be paid to adapt to the solvent will contact plastic parts. Salter treasure contact can't cleaning should be done must be replaced a new contact or scrap processing; 4. Motor and contact wiring should pay attention to keep the insulation skin from damage, prevent the oxidation of the welding point may arise because of be affected with damp be affected with damp and open circuit or short circuit phenomenon occurred; 5. All because of the electric switch machine, soaked in water should be under way or returned to the factory, to give you further with the repair and maintenance; 6. If cannot be handled in a timely manner to do next, continue to use, corrosion resistance, insulation, fall short circuit breakers is inevitable.