Is analyzed. studying bearing seal replacement process

Is analyzed. studying process 2019 - bearing seal replacement 09 - Listing 11 li Inner Mongolia large wind turbines tools: 1 to 1, scissors, loctite 480 glue bottles, flat head hammer 1, 2 the adjustable wrench, 1 to 14 Allen key, and a computer, fan and wheel key 1 to 5, cleaning agents, cloth, trash bags 1 barrel, screw driver, thin iron, oil absorption, 3 pair of rubber gloves. Process: 1, enter a state of fan into maintenance downtime, after entering the cabin is analyzed. studying will stop knob to maintenance after the stop condition will need to replace the blade bearing lock to the below said Y, electrical brake. Open the hub into the mask into the wheel hub; 2 and 3 of the base plate with adjustable wrench bolt after removed the bottom vertical up; 3, use a screwdriver or thin iron to resist dishcloth seal groove, wipe clean with cloth seal belt after put into the bag; 4, cut with scissors to seal belt reserved length is 1 2 cm, glue ( With grain) After lateral sealing belt type sealing groove; 5, take seal cut open after the end of glue on its cross section finish after combined type sealing groove. Note: 1, the seal groove must be clean; 2, sealing tape must put clean bag, pollution prevention; 3, tapping force uniform, sealing strip surface smooth and uneven phenomenon; 4, sealing strip joints without dislocation, gap phenomenon. Work photos: