INA linear bearing with skills pay attention to four points

INA bearing inside diameter size and outside diameter size is made according to the standard tolerance, bearing inner ring and the shaft, the outer ring and a hole with tightness can only by controlling the tolerance of the shaft neck and tolerance of hole. Bearing inner ring with the shaft with the use of hole system, bearing outer ring with a hole with machine shaft system. The first point, to maintain the cleanness of INA bearings and its surrounding environment need not say I will know what is going on, even invisible to the naked eye of dust into the bearings, also can make linear bearing wear, to put it bluntly, knead no sand in the eyes, is a truth! The second point, careful to use installation where you won't even that common sense all can't, if not, then don't do the linear bearing, go home and play, the most important strength is not allowed in stamping, are not allowed to use hammer percussion bearing directly, not afraid of smashed, you give up deformation, how to do, take a loss yourself, ha ha, there is not allowed to pass through body pressure. The third point, using appropriate, accurate installation tools to use a special tool, to avoid use cloth class and short fiber, things like that. Fourth, to prevent the corrosion of INA bearings, don't use bubble bearing is made of stainless steel, but also afraid of water, if not letter, you put in the water bubble, ha ha, take linear bearing, with the hand to wash hands fully the sweat, and again after coated with high quality mineral oils, especially in the rainy season and summer to pay attention to rust, don't tell me the rust of be afraid of what, well, you try it yourself, and see what the result is rust! Right choice to cooperate, we must know the actual load conditions of linear bearing, working temperature and other requirements, but in fact it is very difficult. As a result, most of the time, is according to the use of lapping choice to cooperate.