IKO spherical roller bearings after installation and maintenance matters needing attention

According to relevant data show that when installing IKO bearing damage accounted for twenty percent of bearing damage, how can we reduce when installing bearing damage? The following details for you. Installing a self-aligning roller bearings have specific request for site, site must be kept in dry cleaning, beware of scrap iron, sand, dust, water, into the bearing. Bearing common installation tools have a hammer, tongbang, socket, special plate, screw, mosquito jig, press, etc. , measuring vernier caliper, micrometer, dial gauge, etc. , but according to the different bearing types to choose different tools. After choose the right tools, can the bearing installed, when installation should pay attention to have no bruising, rust layer, abrasive dust, sand, dust and dirt, can cause installation if any difficulty, must keep spherical roller bearing assembly parts surface and cooperate with the surface clean. In addition to IKO bearing surface and cooperate with the assembly parts surface cleaning, also pay attention to the journal, the surface of the bearing shell hole, shoulder end face, and connecting parts such as bushings, washer, end cover rust layer of these places? If there is one can use smooth file away, fine emery cloth, install again. Rolling bearing is precision components, and its use should be measured accordingly. No matter how high performance bearing use, if use undeserved, will not get the desired performance. Attention about the use of spherical roller bearings are as follows: 1, carefully use in use for bearing strong impact, will produce scar and creasing, become the cause of the accident. Severe cases, can crack, fracture, so must pay attention to. 2, keep the bearing and its surrounding clean even the eyes can't see the little dust, will also bring bad influence to the bearings. So, keep the surrounding clean, dust from invading bearing. 3, using appropriate tools to avoid operation with existing tools to replace, must use the appropriate tools. 4, to pay attention to the corrosion of the bearing operating IKO bearings, sweat will become the cause of rust. Pay attention to the operation with clean hands, it is better to try to bring gloves.