IKO import bearing dismantling techniques

Unscrew the fixed bolt of the bearing. Will IKO import bearings together with the bearing seat away from the axis. Shall I bearing bolts loosen, on the other end of the shaft in order to avoid mutual don't IKO import bearing strength and damage. With Allen wrench to loosen IKO import bearing eccentricity on the lock screw, and then with a small iron rod inserted into the roof sink hole on the eccentric sleeve, against the direction of the axis of rotation to play loose eccentric sleeve. A lot of people in the installation of the bearing use improper installation method, cause the damage of IKO import bearings. So how to correctly install IKO import bearings? Hope you more comprehensive understanding of IKO import bearing installation and disassembly: for IKO import bearing ring clearance fit, Suggestions on the fitting surface coated with a thin layer of peristalsis etchant, in case of friction between mating surface corrosion. Series 390000, outer spherical bearing is through the eccentric sleeve bearing inner ring with fixed axis, eccentric sleeve on the socket head cap screw fastening effect. In maintenance, a lot of machinist will not tear open outfit this IKO import bearings, so it is necessary to introduce disassembling 390000 series of spherical bearings IKO import technical key points and matters needing attention: the correct installation, for IKO import bearings use is very important. I hope you can in the later use with correct installation method. When installation, can according to its type and size, select machinery, such as heating or hydraulic method. When installation force on IKO bearing imports, never can be passed on from one roller bearing ring to another IKO import bearing ring, otherwise it may cause damage to the race. But in any case, all can't knock directly bearing ring, cage, rolling body or seals. Eccentric sleeve. The eccentric sleeve installation is firm, finally lock eccentric sleeve on the socket head cap screw. Fixed IKO import bearing bolts do not tighten, let bearing coat in IKO bearing internal energy imports. Then good bearing bolts. Also installed on the same shaft, on the other side of the bearing and shaft turning laps, let IKO import bearings automatic alignment position itself. Coating on surface of the bearing and the bearing lubricating oil, IKO import bearing load bearing. Pushed to the required location for installation. Before install IKO import bearings on the shaft, / you must first remove the IKO import bearing a coat of fixed pin, the shaft neck at the same time clean exterior burnish is smooth, and shaft neck with anti-rust and lubrication oil ( Allows for a slightly bearings on the shaft rotation) 。