IKO bearings used to check operation

Before installing the equipment should be detailed inspections of parts, today we talk about the installation of an important part in equipment operation IKO bearing money detailed inspection. Check all bearing inner parts and remove all burrs. Measurement axis and the cleaning shaft with the shoulder, tolerance of bearing housing and the shape. Check the oil seal, please contact the seller. Bearing opened before installation, please. As far as possible to ensure IKO bearing from the dust pollution. In addition to bearing inner hole and outside surface. Other parts of the rust inhibitor don't have to wipe off. When cleaning is easy to use oil and solvent and dry. Large bearing often apply a thick layer of fat shape seal the surface rust inhibitor. Before installing, usable and clean way to remove them. Spacious clean workplace, room temperature conditions, with the correct installation methods and tools. Installation site should be no metal grains of sand, cement powder such as foreign body. If possible, should be to pack IKO bearing part of the move to repair factory. If once opened not immediately installation, the machine should be covered up, and to keep the bearing is not affected by the environment pollution. Bearing the encapsulation and packaging are first-rate, please open the packing before installation. With a lint-free cloth wipe off the bearing inner hole and outer surface. Be careful not to use waste cotton cloth. And those with extremely low or high temperature grease, synthetic grease lubrication of the bearing, in particular, should be completely clean, to avoid rust prevention adverse impact on the lubricating performance. 1, remove the hand sweat can lead to rust when processing operations, so the hands should be kept clean and dry, when it is necessary to wear gloves. Bearing can only be removed from the original packaging cleaning before assembly. If everything is sealed with volatile corrosion inhibitor paper over the package only took out one of the several sets of bearings, the packaging will be immediately sealed again: VCI paper to protect the gas phase can only be maintained in the sealed packaging, taken IKO bearing grease and oil processing should be done immediately. 2, compatibility and miscibility bearing with anti-rust oil mixed with oil and mineral oil-based compatible and grease to use. If use: synthetic lubricant and lithium base composite soap thickener, should check its compatibility. If you are not compatible, especially in using: ptfe ( PTFF） Or naphthenic base fluorinated ether base lubricant or lubricant containing polyurea thickener, or if the changing lubricant or bearing contamination, should be cleaned before loading fat anti-rust oil. 3, cleaning IKO bearings must be dried after cleaning and rust-proof oil or grease with immediately, in order to prevent rust!