IKO bearing installed in front of the matters needing attention and how to select the application principle

Sliding bearing configuration not only includes IKO bearings, but also related to the bearing parts, such as shaft and bearing seat. Lubricant is also a very important part of bearing configuration, because lubricant to prevent wear corrosion resistance, so that the bearing can give full play to the role. In addition, the seal is also a very important component, the performance of the seal is very important to the cleanness of lubricant. Keep clean and has a far-reaching influence on the service life of bearing, that is why the lubricant and seals have become a part of SKF bearing business. ( 1) Bearing of machinery space and location ( 2) Bearing the load size, direction and nature ( 3) The performance (self-aligning bearing 4) Bearing rigidity in the comprehensive information included in the technical section usually applies to ordinary IKO bearings, or at least apply to a group of bearings. If you only need exact information, a certain sliding bearing may be classified in the corresponding form found in chapters before about the text. After IKO bearing installed, if not done carefully alignment, alignment can lead to bearing suffered another load, friction, and vibration. The use of these may accelerate fatigue and reduce the bearing life, and it might damage the other machine parts service life. In addition, the increase of vibration and friction could significantly increase the risk of energy consumption and premature failure. ( 1) Note with sealed sliding bearings do not clean with this law, the seal of the internal cleaning should remain the same. ( 2) Shaft and the bearing hole assembly there such as bruising, burr, rust stain on the surface or solid particles ( Such as abrasive dust, sand, clay) Such as existence, not only can make the sliding bearing in installation and the installation location is not correct, and solid particles such as falling into a bearing inner grinding effect, when IKO bearing rotating grinding or bruising bearing surface of the work, so must be carefully checked before the installation, if found to have the above defects, should be revised. For example using oil file to remove burrs, bump touch mark, rusty spot, with fine abrasive cloth lighting, such as solid particle, dirt, etc. (cleaning and 3) When installed in the open the bearing assembly, put it into the liquids such as gasoline with handle gently gently turning, to ensure the cage, IKO body and sealing of raceway surface oil thoroughly washed clean.