Extend bearing life, is used for controlling these points

Bearing as an important joint parts, machinery and equipment in order to prolong the life of the use of the bearing, the use of daily maintenance is care and inevitable, for it could make a bearing using appropriate cut longer life, China bearing network after bearing all the aspects of understanding, to share daily for maintenance and enjoy learning about bearing, only need to control these points, for the life of the bearing is clearly did not question. First of all, in order to make full play and to sustain their proper bearing performance, truly necessary to do regular maintenance (care Regular inspection) 。 Second, in bearing regularly check, if there is something wrong with must be to do early detection, prevent accidents in already, is very important for progress rate of consumption and economy. Third, bearing in the factory are coated with the right amount of anti-rust oil and anti-rust paper, just the packaging is not damaged and the quality of the bearing will be guaranteed. Fourth, after registering for a long time, such as bearing in humidity below 65%, under the condition of temperature is 20 ℃ or so, send the shelf there are 30 cm higher than the air is advisable. In addition, the storage place should avoid direct sunlight or contact with the cold wall. Fifth cleaned bearing, bearing maintenance process, the need to stop the steps as follows: a, first of all, the bearing will be removed to check the use way such as photography completes the first recorded appearance. In addition, to confirm the quantity of residual smooth agent and the smooth agent, sampling, and then clean the bearing. B, bearings cleaning rough washing and fine washing to stop, and can be put in use at the bottom of the container on the metal frame. C, coarse, with a brush in oil and other things clear smooth fat or adhesive. If at this time in oil bearing, pay attention to due to foreign bodies such as damage to the rolling surface. D, fine cleaning, turn gradually in the oil bearing, must stop seriously. Usually use detergent for neutral aqueous diesel or kerosene, according to the demand is also sometimes used warm lye, etc. No matter use which kinds of detergent, often should filter stick to clean. E, after cleaning, coating anticorrosive oil or antirust grease on the bearing immediately. Sixth, when stop bearing removal and installation, be sure to use professional tool and the corresponding steps to stop the good bearing device and unloaded safely.