Electromagnetic induction heating type all need to know what information?

Is mostly used in high frequency electromagnetic induction heating equipment, is not as simple as conventional model selection, know the inner diameter of the workpiece, outer diameter, width and weight of these parameters can, so in the high frequency of equipment type selection, all need to know what information? Here the author to discuss with everybody together. Generally set up 110 ℃ can be installed, if it's with a sealing ring, plastic cover, nylon cage, this temperature should not be set too high, can normal set up 80 degrees, and other special bearings will be subject to the bearing inner ring and shaft interference quantity size and bearing is decided by the special heat treatment. Because the ordinary bearing heat treatment temperature is 120 - 150 ℃, and more than it is easier for the bearing temperature annealing reduce the intensity of rigid, affect the service life of bearing. Above is bearing heating temperature, and other special artifacts ( Such as gear, shaft coupling) , mainly depends on the size of the over surplus quantity of the. According to the actual situation to set temperature line, said a little bit more simple is that although the temperature of the equipment is 0 300 degrees can be adjusted, but specific what needs to be set to the temperature, is the need to particular case is particular to treat, if in doubt can communicate specific contact manufacturer to confirm. Bearing manufacturers advisory service hotline:! 【 See who else in WTR bearing 】 : zhejiang hailiang CheJiaXing cement China wind power in China's hubei province is fitting click to see more customer case! The above articles from jiaxing Kurt automation equipment co. , LTD ( ） Reprint please indicate the source