Cylindrical bearings correct installation method

A lot of people when making the installation of the cylindrical bearings, due to the installation in the right way and cause the damage of the bearing and cannot work normally, as a result, the bearing network in this emphasize that the cylindrical bearing the correct installation method is a very important link. Cylindrical bearing the correct installation method of cylindrical bearing installed correctly common there are two ways: one kind is cold installation, the other is a hot installation. Cold installation cooperate is not too tight little bearing installation, can be through a sleeve with hammering method, tapping the sleeve bearing is put into place. Should as far as possible even when knock the effect on the bearing ring, in order to prevent the bearing tilt or skewed. Most of the bearing pressure into the method for installation. If you would have a bearing inner and outer ring loaded on the shaft and bearing seat at the same time, must ensure that the same pressure effect on the outer ring, at the same time, and must be installed with the tool interface on the same plane. Heat installation, normally for larger bearing installation, not by heating the bearing or bearing is impossible, because with the increase of the size, the greater the force needed for the installation. Heat installation needed between the bearing ring and the shaft or housing, the interference temperature mainly depends on the quantity and the diameter of the bearing fit place. Open type bearing heating temperature shall not exceed 120 ℃. Bearings with seals and dust cover is not recommended be heated to above 80 ℃ ( Shall ensure that the temperature does not exceed the seals and the allowed temperature grease) 。 Bearing heating, uniform heating, never can have local overheating. 【 bearing induction heater Warm prompt. 【 The bearing network] Some information from the Internet, and strive to secure timely, accurate, aims to deliver more information, does not represent our views to its approval or responsibility for their authenticity. If this net reprint information involves the issues such as copyright, please contact with this net. Tel: 0571 - 81630205. Tags: install and remove