Clean the bearings need to pay attention to matters

If it is found that the bearing failure symptom, bearing contains impurities such as sand, oil began to stiff, or run 2500 - bearing After 3000 hours, should be cleaning bearing. When cleaning should pay attention to the following matters: ( 1) Bearing of the old oil first, then use brush or cloth dipped in gasoline or kerosene bearing to clean clean, clean at least twice, also wash and dry bearing cover. ( 2) When cleaning shall not be rotating bearing, in order to avoid a pile into the bearing raceway. ( 3) Clean with kerosene bearing, should be cleaned with gasoline. Because contain water more in kerosene, rushed by gas bearing on residual moisture, in order to prevent rust. ( 4) Wash bearings, dry clean wiping cloth should be used, can not use cotton to wipe, lest hair fall into bearing, must not touch the bearing at the same time, in order to prevent the bearing with sweat and rust, wipe the bearing can be on the board or paper clean, let the remnants of gasoline or kerosene evaporation. ( 5) Clean dry bearings, such as no obvious shaking and ball surface flaking off, is in accordance with the provisions, to join the pure oil, put into use again. More contact bearing technical problems: Duan Sheng bearing technology solution