CHK52 CNC lathe handling ( Lifting) instructions

CHK52 CNC lathe handling ( Lifting) Instructions 2019 - 11 - 30 CHK52 series machine tools in the packaging process, adopted a rust sealed packaging and corresponding vibration and impact resistant, can guarantee to survive - 25 ℃ ~ + 55 ℃ temperature limits of transportation and storage, and can withstand temperatures up to 70 ℃, and short-term transportation and storage time less than 24 h. This series of machine tool can be used in the process of transportation forklift or sling for handling. 01 forklift to the machine tool bed are at the bottom of the forklift. Forklift handling ability than the machine weight and have enough insurance factor ( Specific model machine weight can consult technical parameter table data) , forklift hole position as shown. Note: a, when transporting machine, should be especially careful to avoid machine, NC system, such as high voltage switch board hit; 2, before the fork transporting machine, first remove the protective behind the lower coaming, in order to show machine tool bed fork mouth, at the same time check whether the parts is firmly fixed, whether should not be placed on the machine tool, forklift fork up from behind the machine tool machine tool; Three, forklift truck transportation machine shall ensure that the earth is flat and level, otherwise may machine may slip from the forklift truck, caused personal injury and property damage. 02 sling when transporting lifting machine, should be special ordered lifting machine tool suite. CHK52 machine adopts the trapeze hoisting, lifting diagram as shown. According to the following requirements lifting machine: the machine in the process of transportation, shall, first of all, the door is fixed. Using the crane is equipped with the packing machine, must according to the external lifting machine packaging mark using the lifting rope, try to reduce the packing by all kinds of shock and vibration, mobile and put down, should not make the bottom and side impact or severe vibration, packing excessive tilt is not allowed to avoid affecting the precision of the machine tool and even damage, use rollarounds mobile packing cases on the slope, the oblique Angle shall not be more than 15 degrees, rollarounds shall not exceed 70 mm diameter, forbid to equipped with machine tool boxes on the objects with sharp edges or upside down, so as not to affect the accuracy of machine tools. Broke open the packing cases, first check the external condition of machine tool, according to the product of the packing list inventory accessories and tools are complete. With crane has been out of the machine, must according to the picture above, must use framework for lifting sling. And use the bed saddle and end balance, such as lifting, minimum bearing must be greater than 4 tons of single wire rope. Wire contact with the machine, and contact with the protective plate must use wood mat, or on the surface of wire rope set of rubber tube, in order to avoid lifting machine tools and protective plate, etc. Note: one, the demolition of aluminum-plastic film before lifting, and check the machine appearance is in good condition, should be especially careful to avoid lifting machine tool NC system, high voltage switch board, etc. Before the lifting machine, should check whether each part is firmly fixed, whether should not be placed on the machine tool. Especially the door should be fixed immobile, cooling box should separate transportation; Second, to keep balance suspended move upward in the vertical and horizontal machine tool, therefore, in machine tools is just out of the ground, it must be make ensure balance; Three steel wire rope, lifting Angle shall not be greater than 60; Fourth, whenever the lifting machine, as long as it's not a person to perform, between the given signal should be taken to work together. （ Source: shen a lathe factory)