Auto water pump bearing storage and installation, you know?

Compared with the mechanical parts as usual, water pump shaft bearings are precision components, so storage should be especially alert when using. Company water pump shaft bearing in the factory when you are with the right amount of anti-rust oil and antirust packing, as long as the packaging is not damaged, will be guaranteeing the quality of bearing. Store, in humidity below 65%, under the condition of temperature is 20 degrees, stored in the shelf 30 cm above the ground is advisable. Other, storage place to avoid direct sunlight or with the walls of the cold war. Water pump bearing is precision mechanical parts, the seafarer is particularly carefully. Link of bearing and surroundings clean, device to clean, raided the shell and the flange, impeller, water seal and bearing relevant process documents processing which is confirmed and no scar or mechanical processing of burr, chip, etc. The seafarer should use proper, restraint axis suffer violent blow and incubated scars, fracture and other damage. When the device is bearing in the shell of the time, it is necessary to carefully watch and resettlement work for ball and roller to watch this kind of environment, must use only and the outer appearance of war funding, and should use the mechanical pressure. When device, water pump shaft, impeller and mechanical seal hole must and spindle modulation draw. Must be applied mechanical stress, and the other surfaces of the shaft must be supported by police incubated give force applied to the ball. In all applications in the realm of the temperature of the shell and the bearing outer ring interference results must be linked together. At the same time must provide adequate support police channel deformation. If interference fit joint is too light, bearing will slip out of the shell, if only the common is too heavy, incubating channel distortion. Housing requirements: aperture < 0. Per 25 mm hole 010 mm long taper < 0. 007 mm smoothness: when cold, the material of the smoothness of cutting volume growth will change seat hole. , in the process of pressure into the hole of the shell material deformation, cause when tight force decreases. This depends on the shell hole appearance of smoothness and the choice of the material. This article from: auto water pump bearing, shaft bearings, water pump bearings ( ) A: on the analysis of the water pump bearing causes problems for you next article: introduction to the installation of the water pump bearing water pump bearings manufacturer matters related tags: auto water pump bearing, water pump bearings, automotive water pump bearings, auto water pump bearing related news which cases will fever auto water pump bearing thermal and bearing performance of engine cooling system of key parts of automotive water pump bearing water pump bearing why use general auto water pump bearing grease appears channeling dynamic circumstance how to deal with related products