Auto water pump bearing installation using the environment

Auto water pump bearing is installed, on the circumference of the ring width must be equal pressure, and then to press the ring into, avoid using ð ¨ +  top tools of bearing face directly hit, and damage When the water pump bearing interference amount is larger, can use oil bath heating heating (or sensors The heating temperature range of 80 ℃ - 100 ℃, the highest should not exceed 120 ℃) To install the bearing method. At the same time, in order to prevent bearing cooling later width shrinkage and make clearance between the ring and the shaft shoulder produces application, nut fastening bearing or other appropriate method. When the water pump bearing in the case of a small amount of interference, using ð ¨ +  head banging on sleeve, through the sleeve ring is balanced Fashionable, should guarantee the outer end face and the shell shoulder end face ( At room temperature with the sleeve pin bearing ring width) , inner ring end face and the shaft shoulder end face pressure, there is no clearance) 。 Hydraulic press used for the installation of large quantities of water pump bearing. A: after the installation of bearing rotating test next article: auto water pump bearing the development direction of related tags: auto water pump bearing, water pump bearings, automotive water pump bearings, auto water pump bearing related news which cases will fever auto water pump bearing thermal and bearing performance of engine cooling system of key parts of automotive water pump bearing water pump bearing why use general auto water pump bearing grease appears channeling dynamic circumstance how to deal with related products