Analysis of self-aligning ball bearing using the environment temperature and matters needing attention

TIMKEN bearing temperature is too high in the rotation for machine will produce larger damage, so as far as possible in the use of the environment temperature control at 100 degrees, the cause of self-aligning ball bearing temperature may be: 1. Lubricating oil is insufficient or doped impurity 2. The installation of the bearing is not correct. 3. TIMKEN bearing load is too big or friction, clearance adjustment is not correct. 4. Bearing vibration is too large, in the process of rotating bearing process does not conform to the requirement of self-aligning ball bearing is a precision components, its use should be measured accordingly. No matter how high performance using TIMKEN bearings, if use undeserved, will not get the desired performance. Use of self-aligning ball bearing the note below. A, keep the self-aligning ball bearing and the surrounding environment clean even invisible to the naked eye the tiny dust self-aligning ball bearings, also can increase the bearing wear, vibration and noise. Self-aligning ball bearing and its surrounding accessories should be kept clean, especially the dust and dirt, tools and working environment must be clean. Second, use the installation should be careful when not allowed powerful punch, are not allowed to use hammer, direct hit self-aligning ball bearings, don't allow through the transfer roller pressure. Three, using appropriate and accurate installation tools use a special tool, as far as possible to avoid use cloth class and short fiber, things like that. Four, to prevent rusting of self-aligning ball bearing directly take self-aligning ball bearings, with the hand to wash hands fully the sweat, and again after coated with high quality mineral oils, especially in the rainy season and summer to pay attention to rust. However, in some special operating conditions, can obtain a longer than traditional computing by TIMKEN bearing life, especially in the case of light load. These special operating conditions is, when the rolling surface ( Track and rolling piece) Can be separated by a lubricating oil film effectively and the surface of the limit of pollutants may cause damage. In fact, under ideal conditions, the so-called permanent self-aligning ball bearing life is possible.