Stainless steel bearing inspection project operation

Stainless steel bearings after installation, running inspections should be immediately, to determine whether the installation is normal. In order to make the performance of the rolling bearing is in good condition to maintain long-term use, must carry on the inspection and maintenance of the bearing, this kind of inspection and maintenance, it is very important to prevent failures in advance. According to hope for machine condition for operating standards, stainless steel bearing operation check project have bearing rolling noise, vibration, temperature, lubrication condition and so on. Specific inspection items are as follows: ( 1) Sound rolling bearings of rolling with the sound of the measuring device of stainless steel rolling bearing in operation check, usually bearing once detachment of slight injury, such as would an exception and irregular, and with the sound of the measuring device can distinguish, noise is low, the production of stainless steel bearing problems can be clearly heard. ( 2) Vibration using special gauge measuring size of stainless steel bearing vibration in operation, through the frequency distribution can infer the abnormal situation, measured values due to the use of the bearing condition or sensor installation location, there are different, so need prior to each machine is analyzed by the measured value of the determined after judgment standard. Operation in the process of operation of bearing vibration signs can also predict abnormal in general. ( 3) Temperature bearing temperature, average outdoor surface temperature can be predicted by the bearing, if using the oil hole can directly measure temperature of bearing outer ring is more appropriate. Usually 1 - bearing temperature as operation began to slowly rise After 2 hours to reach steady state. The normal temperature of bearing for machine and different heat capacity, heat dissipating capacity, rotational speed and load. If the lubrication, installation is not appropriate, the bearing temperature will go up sharply, there will be abnormal high temperature. Then must stop and take the necessary precautions. ( 4) Lubricated bearing lubrication method is roughly divided into two kinds of grease lubrication and oil lubrication. In order to give full play to the function of the bearing, the important thing is according to the conditions of use and purpose using different methods of lubrication. Stainless steel bearing manufacturer remind you carefully check when the stainless steel bearing is running can ensure bearing operating normally, to avoid improper operation bearing jammed or mechanical failure, must be careful to work seriously at work more efficient.