Spread the bearing out of way of explanation - bearing knowledge

When bearing retainer fall apart, ball converge to one side. When open change, NSK bearing inner sleeve and the coat is not a body. The first step, measured with vernier calipers bearing a coat of inner hole diameter, for instance, is 55 mm. The second step, saw a piece of about 20 mm wide, about 5 mm thick, long approximately 60 mm plate. The third step, in the middle of the plate, and a center hole. The fourth step, in order to center hole, centered with round planning a 58 mm diameter of the original curve. Fifth, on the grinder, put the spare parts other than the original curve according to the original curves trimming. Step 6, bend iron hammer, hammer ( Notice camber wants even) Using vernier calipers measurement hammer after bending plate length, the size is 55. 5MM。 Step 7, on the center hole, with 5 mm drill into a hole. Using M6 screw tap set button. Step 8, find a long buckle the M6 screw from the concave surface of the iron bar of screw in ( Just outcrop) Step 9, convex it forcefully into the bearing outer ring in the direction of the 'dead end' ball groove. Step 10, the long screw to tighten the direction of rotation, at this point, bearing a coat of the 'dead end' is likely to come out! The first ten step, if really not line, take the magnets to suck, also can give suck out the coat! Step 12, did not have, if not yet, that means bearing meltdown.