Spindle bearings cleaning method and lubrication way have?

Spindle bearing the correct configuration refers to the combination and bearing type bearing arrangement, before and after different configuration determines the spindle different load capacity, speed, stiffness, temperature and service life, the spindle in the various components are very close, if one of them is damaged, will affect the operation of the main shaft, so the main shaft in use after a period of time is the need for cleaning and lubrication, to guarantee the normal use of the bearing, is by the author to explain for everybody below the main shaft bearing cleaning method and mode of lubrication. A cleaning and 1, spindle bearing, bearing generally use kerosene or gasoline as a cleaning fluid. 2, separate the rough washing and fine washing cleaning trough, and metal mesh pad on the bottom of the channel respectively, make the dirt inside the bearing is not direct contact with the cleaning trough. 3, wash the groove in the coarse, try to avoid a rotating bearing, etc. With the brush after roughly clear the dirt on the adhesion in the bearing surface, in on the fine cleaning trough. 4, in fine cleaning tank, bearing rotation to gently to clean. Fine cleaning tank cleaning oil must always keep clean. 5, cleaning after degreasing, if it is a grease, lubricating grease filling work. If the lubricating oil and gas, as far as possible under the conditions of bearing not rotating, installed on the spindle. 2, 1, bearing spindle bearing lubrication way wash after filling the order of the grease grease filling method is different, can produce the early break in the warming of the instability, abnormal temperature, running in the early time is long, and even burn. Therefore must according to the conditions of use, using the appropriate amount of grease and proper filling to properly filled in. 1) Fill the confirmation matters before the bearing internal no residual foreign matter. Recommended for high speed spindle bearing, should be cleaning, degreasing, then fill the grease. Other applications, are suggested to remove adherent inside the bearing anti-rust oil first. 2) Fill grease to fill the right amount of grease, it is recommended to use fat injection. The number of using readable note the injector. 3) The angular contact ball bearing grease filling quantity of high-speed spindle, space volume of 15% and 20%, motor ball bearings, the space volume 2, cylindrical roller bearing grease filling method 1) Will fill the amount of 80% of grease, paint roller rolling surface evenly. At this moment, it is recommended that the cage inside don't apply too much grease. Grease the inside of the cage, the break in the early stage, more difficult to spread, can make the temperature increased, will extend the time of break-in. 2) Roller on the surface of the raceway grease will spread to end surface of the roller, maintains contact with the roller part, and the entrance of the pocket hole, the grease evenly distributed to the bearing as a whole. 3) Will fill 20% of the amount of grease, uniform thin paint will be installed into the bearing outer ring raceway surface. Above is the author explain for everybody about the spindle bearing the entire contents of the cleaning method and lubrication way, hope you have read will help, to sum up, bearing in use after a period of time is required for regular maintenance and cleaning, in order to better use, prolong life, reduce wear and bearing has a good pre-market after-sales team, solve your problem of technology research and development team, to provide free technical guidance for you, you are welcome to call consultation of choose and buy. Tags: spindle bearings cleaning method