SKF bearing failure factors of common treatment methods

Installation conditions is one of the primary factor of use factor, sliding bearing is often caused by improper installation of a complete set of change the stress of bearing between various parts, bearing in the abnormal state run and early failure. According to the thrust ball bearing installation, use, maintenance, maintenance of technical requirements, SKF bearing in operation on the load, speed, temperature, vibration, noise and lubrication condition monitoring and inspection, found that abnormal immediately to find the reason, adjustment, so that it is back to normal. Installation conditions is one of the primary factor of use factor, bearing is often caused by improper installation of a complete set of change the stress of bearing between various parts, the sliding bearing in abnormal state run and early failure. According to the sliding bearing installation, use, maintenance, maintenance of technical requirements, SKF bearing in operation on the load, speed, temperature, vibration, noise and lubrication condition monitoring and inspection, found that abnormal immediately to find the reason, adjustment, so that it is back to normal. SKF bearing fracture fall effect secondary reason are the two general defects from overload. When the applied load across the material strength limit and fracture forming parts called overload fracture. Overload causes minor from machine and dismantling of sudden trouble or wrong. Bearing parts of micro crack, shrinkage cavity, bubbles, large foreign impurity, overheating organizations and local burns and other defects are will impact overload or violent vibration are defect provoked fracture, referred to as a defect fracture. Should point out that sliding bearing is making process, this material into the factory reinspection, cast and heat treatment of measure control, process control by instrument precise exposition of the above defects can not, then still must strengthen self-control. But generally speaking, all of bearings breaking off effect greatly for overload. SKF bearing is doing outside work, because of the influence of outside or inside elements are changed, there is no common gaps reduce accuracy, and even form 'killed' called around gap change effect. And dismantling of external factors, such as a defect is too big, does not reach the designated position, temperature rise provoked the bentonite shrank, instantaneous overload, etc. , are elements such as broken in austenite and broken when force is in formation, etc are not not disorderly around gap change effect of secondary causes.