KOYO check before the installation of the rolling element bearing maintenance work

Judgment standard according to the mechanical properties and important degree and inspection cycle. If you have the following injury, KOYO bearings shall not be used again, must be replaced. In the process of using the bearing, the grease is critical. If bad grease, used, not only don't function, and can also damage of rolling bearing. Take two cups, one of which need to be checked out of the lubricating oil, empty on the desktop, the other will leave the measuring cup with lubricating oil for high 30 - desktop 40 cm and tilt, let oil flow slowly to the empty cup, to observe the flow situation, good quality lubricant oil flow should be long and thin, uniform, continuous, if appear oil flow fast and slow, and sometimes has a large flow, the said lubricating oil has deteriorated. Be twist lubricating oil between the thumb and forefinger grinding, good lubricating oil hand feel less lubricity, wear debris, no friction, if feel fingers between the larger friction feeling such as sand, suggests that the impurity, lubricating oil can no longer use, a new lubricating oil should be replaced. ( 1) Before KOYO bearing installation, should use the appropriate measuring tools according to the provisions of the technical requirements on the design drawing check the shaft and hole and machining quality of parts ( Such as dimensional accuracy and shape accuracy and surface roughness, etc. ) 。 ( 2) Shaft and the bearing hole assembly there such as bruising, burr, rust stain on the surface or solid particles ( Such as abrasive dust, sand, clay) Such as existence, not only can make the rolling bearing in installation and the installation location is not correct, and solid particles such as falling into a bearing inner grinding effect, when bearing rotating grinding or bruising KOYO bearing surface of the work, so must be carefully checked before the installation, if found to have the above defects, should be revised. For example using oil file to remove burrs, bump touch mark, rusty spot, with fine abrasive cloth lighting, and like a clean solid particles, dirt, etc. ( 3) Should be assembled with clean the surface of the gasoline, kerosene, toluene and xylene solution washing clean, with dry clean duster cloth, and then coated with a thin layer of lubricating oil, it can make the operation more convenient installation. ( 4) When installed in the open rolling bearing encapsulation, put it into the liquids such as gasoline with handle gently gently turning, to ensure the cage, encapsulated oil on the surface of the rolling element and raceway thoroughly washed clean. ( 5) When cleaning a lot of KOYO bearing, with the first temperature is 90 ~ 100 ℃ heat oil pour hot to melt encapsulated oil, at the same time with seamless all mouth and no net exfoliation tools to dig the old oil, then pour hot a few minutes, then rinse with kerosene oil, clean with gasoline again finally. After washing clean, on film gloves should be worn to rolling bearing on the worktable of dry clean cloth or paper. ( 6) Note with sealed KOYO bearings do not clean with this law, the seal of the internal cleaning should remain the same.