KOYO bearing lubrication and operating principles of production

Satisfactory KOYO bearing service life started in the right bearing selection. From the beginning, bearing designers by choosing the right bearing for different application to prolong the service life of the bearing and equipment performance. This process should consider many factors, such as load, hardness, bearing life prediction, running environment, etc. In principle, all bearing before installation should be stored in their original packaging. They need to stay clean, no moisture, relatively constant temperature environment. Rolling bearing should stay away from dust, water and corrosive chemicals. Shaking and vibration may be forever on the mechanical properties of the damaged bearing, so the vibrations must be avoided in the process of handling and storage. Basically, all KOYO bearing must be level to save, because some of the heavier bearing long upright, may deformation due to its own weight. In advance (coated with grease Or sealed) Bearing need to be especially careful, because the grease will change after long time of storage density. So when the bearing is used for the first time, there will be a certain degree of rotation noise. Therefore, this kind of bearing on time should be controlled according to the principle of first in first out. In the operation process at ordinary times, how to moderate in the lubrication of bearings and bearing maintenance and maintenance is one of the important link that nots allow to ignore. Oil bath is bearing in the ordinary way of smooth smooth, suitable for low and medium speed bearing is smooth. Will KOYO bearing a partial immersion in the slot, smooth and bring up the oil by the rotation of the bearing parts, then flow back to the oil level of oil tank should be slightly lower than the lowest in the middle of the roller. Drip smooth smooth oil bearing components, suitable for the need to ration the drops of oil every 3 - individually A drop of it is advisable to 8 seconds, too much oil will cause the bearing temperature increased. Walks in oil pump will be filtered oil to the bearing parts, through the bearing smooth oil filter cooling after use. Because circulating oil can take away heat, must make bearing cooling, therefore method suitable for high speed bearing parts. In dry contraction by the sprayer and smooth air oil mixed oil mist, radial bearings, can effectively make the bearing cooling airflow and can avoid intrusion. This method is suitable for high speed and low temperature bearing parts is smooth. With oil pump nozzle shot into the bearing, the oil in the low pressure into the bearing of the bearing at the other end into the oil in the tank. When bearing at high speed, rolling body and maintain frame to match the rotation of the high speed air cause air flow around, it is hard to smooth the oil to the bearings in individual smooth way, then must smooth oil spray with low radiation to KOYO bearing, the status of the nozzle should be placed in the middle of the inner ring and maintain frame between.