Knowledge of daily maintenance - bearing drive shaft

Transmission shaft of the inspection and maintenance for different ways to drive a car. For the rear wheel drive car, drive shaft is not patterned constant speed universal joint with two. If the relaxed clutch started, or snap acceleration, and deceleration car coming from kaka, not patterned constant speed universal joint connector need to replace. Another check method is to seize the underneath shaking around the shaft, if the rotation Angle is 45 degrees, it means not patterned constant speed universal joint gap is too big, need to repair. Front-wheel drive cars with patterned constant speed universal joint, drive shaft in the joint part with rubber seal, the owner must often check of the condition of the rubber sleeve. Because once the damage, the sand will run when driving into the universal joint, accelerated wear and shorten life. Check whether the rubber sleeve is broken is easy: if the wheels and engine found near bottom plate is very thick oily be soiled, or on the road to the steering wheel to play exactly applauded with sound, showing cardan joints have been damaged, should be replaced. In addition, the owner should try to avoid to hit the steering wheel in place, because it will cause the cardan joint because of the heavy load and shorten life.