Install the needle roller bearing have skills

Needle roller bearing have skills needle bearing installation accuracy, a direct impact on the bearing performance and life. So, in today's article, small make up teach you how to install the needle roller bearing. Interested friends may wish to come and see! How to install the needle roller bearing: 1, to press the bearing into bearing before washed with kerosene, with clean hands daub evenly fill shell 3 lithium base grease to the two-thirds full to roller bearing outer ring, use add bolt locking glue binding bolt clamp mount NTN bearing gland; 2, if there are any models inside and outside is set of separable bearing cylindrical roller bearing, bearing suits on the rotating shaft and should be in place; 3, if there is a grease oil hole must aim at the position, use add bolt locking glue binding bolt bearing seat, the bearing seat is installed on the casing; 4, roller bearing with shaft key need to reload the eccentric shaft key into the key block, with a collar on the rotating shaft, inside and outside the eccentric block is installed on the rotating shaft and in place; 5, the rotation of the roller bearing adjustable eccentric block to make it to remove the Angle position and tighten the bolt, before the tight the bolt fixed eccentric block; Six, the last step is to use screw fastening on vibration motor on both ends of the cover. This article is from http://www. czyczc。 Com /, welcome to reprint!