Inspection of SKF bearing vibration and temperature - bearing knowledge

1, the vibration of the bearings SKF bearing vibration is sensitive to bearing damage, such as peeling, indentation, rust, crack and wear will be reflected in the deep groove ball bearing vibration measurement, therefore, through the use of special bearing vibration tester ( Frequency analyzer, etc. ) Can measure the size of the vibration, through frequency points cannot deduce the abnormal situation. Measured values of bearing or sensor installation position and different using conditions, thus requiring prior to each machine is analyzed by the measured value of the determined after judgment standard. 2, the temperature of the bearings SKF bearing temperature, usually have a bearing on the surface of the outdoor temperature can be predicted, if using the oil hole can directly measure temperature of bearing outer ring, is more appropriate. In general, the temperature of the deep groove ball bearing with bearing operation began to slowly rise, 1 - After 2 hours to reach steady state. The normal temperature of bearing for machine heat capacity, heat dissipating capacity, rotational speed and load. If the appropriate lubrication, installation department, the bearing temperature will rise sharply, SKF bearing will appear unusually high temperature, must stop at this moment, take the necessary precautions. Using thermal device can monitor the bearing temperature at any time, and realize e. automatic alarm when the temperature exceeds or stop to prevent the shaft accidents. With high temperature often said bearing is in abnormal situation. High temperature also harmful to the bearing lubricant. Sometimes deep groove ball bearing overheating can return to the bearing lubricant. If the bearing temperature for a long time even the transfer of more than 125 ℃ lower bearing life. The causes of high temperature bearing include: lubrication inadequate or excessive lubrication, the lubricant. Contains impurities, heavy load, bearing damage, clearance, high friction and oil seal and so on. So the continuous monitoring of deep groove ball bearing temperature is necessary, whether measured bearing itself or other important parts. If it is on the basis of the operating conditions, the temperature change of any fault has occurred. Regular bearing temperature measurement by using a thermometer, digital thermometer, for example, can accurate bearing temperature measurement and display by ℃ or Fahrenheit units. The importance of bearing, means that when the damage cause of equipment downtime, so this kind of deep groove ball bearing should be equipped with best temperature probe. In just under normal circumstances, SKF bearing lubrication or lubrication after there will be a natural temperature rise and the last one or two days.