Imported fag magnetic bearing characteristics and operating inspection

1 a, imported fag magnetic bearing features. Bearing is high precision, stable work, reliable. 2. Can run in high temperature, cryogenic and vacuum environment. 3. Complicated structure, which requires strict, has magnetic disturbance to the environment, but no other pollution. 4. Small friction, low power consumption, which can realize high-speed operation. 5. Dc excitation type bearing type can only be active ( Active) 。 6. Permanent magnet type bearing is only passive type (the Passive) Passive type bearing, and can't be stable in three directions, at least one direction should adopt active type. 7. Repulsion type magnetic bearing, because of the low utilization rate of magnetic force, structure of the suction type complex, rarely used. 8. Pure type electromagnet bearing is only five degree of freedom control type bearing, its size, quality and power consumption is larger. Second, check the bearing after the installation, operation in order to check whether the installation is correct, to the examination of the operation, small mechanical rotate confirm whether can use the hand well. Check project has caused by foreign bodies, scar, indentation and seized up, bad for installation and the installation seat processing bad and the imbalance of the rotating torque, the seal clearance is too small, the installation error caused by friction torque, etc. If there is no abnormal can start power operation. Because of heavy machinery can't manual rotation, so the no-load start immediately after turn off the power, to inertia, check whether there is presence of vibration, noise, rotating parts contact, etc. , confirmed that operate without exception into power. Dynamic operation, from the beginning of the no-load speed, rated operation conditions to slowly. Test run to check the items, whether there is abnormal sound, leakage of the transfer of bearing temperature, lubricant and discoloration, and so on. In test run if discovery is unusual, should stop immediately, check the machine, it is necessary to unload bearing inspection. Check general appearance supposedly from housing bearing temperature. But using the oil hole, direct measurement of bearing outer ring temperature, more accurate. Bearing temperature began to rise, without exception, usually stable after 1 ~ 2 hours. If because of the bearing or install such bad, bearing temperature will rise sharply, abnormal high temperature. The reason such as lubricant, bearing clearance is too small, too much bad installation, excessive friction sealing device, etc. High-speed rotation, bearing the lubrication methods selection error is also the reason.