Imported bearing installed remove operation requirements

When the bearing is in use process, sudden damage to bearing replacement, of course we in bearing maintenance, removal and installation will be carried out on the bearing, if not properly to install or remove the bearing, could lead to bearing cannot be used properly, or cause bearing normal operation is likely to lead to the following problems or accidents. China bearing network tell everyone bearing installation is important when disassembling operation process, so we need to pay attention to the operation requirements: 1, the power works together as much as possible through the axis of the imported bearing, which requires the screws evenly symmetry and smooth, by spherical or parallel to the axis force application. 2, the size of the wire should be smooth and uniform, unfavorable impact, this request can use hydraulic or use steady pull or pressure tool, it had to use hammer, also want to through soft without exfoliation metals such as copper sleeve to buffer, tapping force as gently as possible. It is best to use copper or copper hammer hammer. 3, avoid by applying pressure roller, which requires the inner ring (installation Axial circle) When applying pressure through the inner ring and outer ring installation) Through the outer power works. 4, the extent of the drag force continued to be, for example when installing imported bearing in the bearing fit into the correct position to stop work, guarantee the ring ( Washers) The end face of landing on a hole or shaft shoulder end, neither packed too tight, nor does not reach the designated position. 【 Warm prompt. 【 The bearing network] Some information from the Internet, and strive to secure timely, accurate, aims to deliver more information, does not represent our views to its approval or responsibility for their authenticity. If this net reprint information involves the issues such as copyright, please contact with this net. Tel: 0571 - 81630205. Tags: install and remove