IKO spindle bearing selection using smooth fat need to take care of that problem

In order to better play to the best situation, the stand or fall of IKO bearing selection directly related to the stable operation of the equipment. Smooth machine tool spindle bearing grease choice must stop thinking from the following aspects: 1. Rust inhibitor is best can not dissolve in water. Grease should have good adhesion, use within the machine tool spindle bearing grease must have antirust effect. In the steel surface and can constitute a layer of oil film. 2. Cause leaks. During normal operation, oil will become soft in machining. Grease the flyflap to IKO bearings. If the mechanical stability of the oil is insufficient, operation process, can make the soap grease attack mechanical disruption in the construction of the formation of oil have been destroyed and thus lose the smooth effect. 3. Bearing operation process, the oil seal is necessary maintenance of the machine tool spindle bearing and smooth agent from outside the barrier of pollution. Regardless of sundry or moisture can penetrate IKO bearings, to prevent formation of its destruction. Correct installation is one of the important elements play a bearing using longest life care. At the same time, must pay attention to the purity of the bearing, bearing of correctness and choose the proper installation and remaining tools. In addition, bearing necessary to avoid contamination by pollutants and moisture, and ensure that the right be installed and smooth. Therefore, the design of the bearing arrangement, oil seal, smooth agent type and smooth cycles, and specially the plays the same care and important role. Of course, if the imported bearing working speed is very low, and needs work in contamination and wet environment, preferably in IKO smooth filling grease in the bearing seat. Especially in the vertical shaft or the application of axis tilted at a certain Angle. Smooth fat and sealing role at the same time, to avoid the contaminants, moisture or water on the influence of the bearing. But if smooth excess fat, will incur spindle bearing operating temperature rise, especially in the application of high speed. Big local conditions, as long as in the beginning stage to full fill the smooth bearing grease, and smooth only fill the right amount of grease in the bearing and leave some free space. Reach work in full speed before, it is necessary to smooth an excess of fat in the running-in stage discharge IKO bearings, to make smooth the right amount of grease in the bearing. When working temperature obviously landing, said smooth running-in grease with bearing, and evenly distributed in the bearing configuration.