IKO rolling mill bearing repair and maintenance of the basic methods - bearing knowledge

Generally, if the correct use of IKO bearings, can be used to achieve fatigue life. But there will be unexpected injury prematurely, not resistant to use. This early damage, as opposed to a fatigue life, is called the quality using limit of fault or accident. Much due to the installation, use, do not pay attention on the lubrication, intrusion of foreign bodies from outside, to the shaft, shell heat affected study enough. On the damage state of rolling mill bearing, such as: roller bearing ring guard card, as a reason to consider, lack of lubricant, not suitable for, for the defect of oil discharge structure, foreign invasion, bearing installation error, the deflection of the shaft is too large, also can have these reasons. Therefore, investigation of rolling mill bearing damage, only the true cause of damage is hard to come by. But, if you know the IKO bearing the use of machinery, conditions of use, bearing the surrounding structure, to understand before and after the accident, combined with several damage status and causes of IKO bearing, can prevent the similar accident happen again. Use about IKO bearing the note as follows: keep rolling mill bearing and its turnover clean even the eyes can't see the little dust, will also bring bad influence to the rolling mill bearing. So, keep the surrounding clean, dust from invading bearing. Carefully use strong impact in use for rolling mill bearing, will produce scar and creasing, become the cause of the accident. Severe cases, can crack, fracture, so must pay attention to. Avoid using the appropriate mill operation tools to tools to replace the existing bearing, must use the appropriate tools. We often stressed the importance of tools, because there are too many customers using the wrong tool in the installation of the rolling mill bearing damage. To pay attention to the corrosion of rolling mill bearing operating mill bearing, sweat will become the cause of rust. Attention should be paid to operation with clean hands, best gloves as far as possible.