IKO roller bearing sealing gasket installation and matters needing attention

IKO roller bearing seal installation is mainly in order to prevent grease spill or foreign invasion, leading to problems such as bearing damage, the bearing network share about IKO roller bearing sealing gasket installation and relevant points for attention. IKO roller bearing sealing gasket installation when inserted into the shaft, as shown in figure 1, shown in the upper side of the shaft end face for chamfering processing can prevent damage when insert the lips. If you can't face of shaft processing, as shown in figure 1, please, as shown in the side of the lower part of the installation using liner. Press the sealing gasket figure 1 into the bearing seat, don't directly tap on a sealing gasket, and application of gradually into fixture tools, etc. In order to prevent early wear and heat sealing gasket parts, OS in labial ministry front, DS coating or filling between two pieces of labial ministry bearing grease lubrication. Installation: IKO roller bearings need to be aware of when using sealing gasket items: 1, a lip OS labial ministry toward the inside of the used when used to prevent leakage of grease, when used to prevent foreign matter into the lips towards the outside. Two pieces of labial ministry DS can effectively prevent leak grease and dust, used to prevent leakage when the labial ministry toward the inside of the grease, when used to prevent foreign matter into the main lip used towards the outside. 2, working temperature range for - sealing gasket 20 ~ 100°C。 More than this range when using need special sealing gasket. 3, axis allowable speed owing to the different working conditions, the circumference of - As for 6 ~ 8 m/s. If the working conditions, such as temperature, lubrication, shaft finishing good, sometimes can be used within the circumferential speed of about 2 times.