IKO bearing disassembly and installation techniques

Unscrew the fixed IKO bearing bolt. IKO bearings along with IKO housings from shaft to unload. Shaft should be at the other end of the IKO bearing bolts loosen, so as to avoid mutual don't IKO bearing strength and damage. With Allen wrench to loosen the first IKO bearing eccentric locking screw, and then with a small iron rod inserted into the roof sink hole on the eccentric sleeve, against the direction of the axis of rotation to play loose eccentric sleeve. A lot of people in the installation of IKO bearing use improper installation method, cause the damage of IKO bearings. So how to correctly install IKO bearing? Hope you more comprehensive understanding of IKO bearing installation and disassembly: for IKO bearing ring clearance fit, Suggestions on the fitting surface coated with a thin layer of peristalsis etchant, in case of friction between mating surface corrosion. 390000 series outer spherical IKO bearing by eccentric sleeve IKO bearing inner ring with fixed axis, eccentric sleeve on the socket head cap screw fastening effect. In maintenance, a lot of machinist not disassembling the IKO bearing, so it is necessary to introduce disassembling series 390000, the main technical points of the outer spherical IKO bearings and matters needing attention: the correct installation, for using IKO bearing is very important. I hope you can in the later use with correct installation method. When installation, can according to its type and size, select machinery, such as heating or hydraulic method. Force of IKO bearing when installation, must not passed on from one IKO roller bearing ring to another IKO bearing ring, otherwise it may cause damage to the race. But in any case, all can not directly hit IKO bearing ring, cage, rolling body or seals. Eccentric sleeve. The eccentric sleeve installation is firm, finally lock eccentric sleeve on the socket head cap screw. Fixed IKO bearing bolts do not tighten, let IKO bearing coat in IKO bearing internal energy. Then IKO bearing bolts. Also installed on the same shaft IKO bearing and on the other side of the seat, shaft turning laps, let IKO bearings automatic alignment position itself. In IKO bearing lubricating oil and IKO bearing fitting surface coating, the IKO bearing load IKO bearing seat. Pushed to the required location for installation. To the shaft is installed on imported IKO bearings before, you must first remove the IKO bearing a coat of fixed pin, at the same time the journal clean exterior burnish is smooth, and shaft neck with anti-rust and lubrication oil ( Allows for a slightly IKO bearings on the shaft rotation) 。