Group co. , LTD. : the installation of stainless steel bearing

Jiaxing bearing group sales co. , LTD. , is the spot sales center of jiaxing bearing factory, specializing in HRB bearings, application in production design and related machinery has a wealth of technical experience, today we are together and we learn the installation of stainless steel bearing. The installation of sleeve bearing installation to ensure there is proper clearance between shaft and bearing, so that the formation of lubricating film. Bearing with wide hole should be a proper tightness, in order to prevent the bearing during operation with the axis of rotation. Specific requirements are as follows: (1) shall examine the bearing pressure in front of each size is in accordance with the requirements, the presence of defects, and wipe the dirt on the surface of the contact, grease, oil, cleaning and holes on the body hole. (2) according to the location on the stainless steel bearings in the body and the size of the bearing, choose the right tools during installation. (3) after the bearing pressure equipment shall be of non interference fitted with fixed screw or pin, and check the inner diameter is in line with the requirements, such as deformation, must be, generally adopt the method of boring, reaming and scraping. To open the installation of the sliding bearing (1) to open sliding bearing is usually called bearing shell, before installation should clean oil, oil tank, the matching surface, check the bearing with the oil hole on the bearing bush is relative. Pay attention to clear the antirust wax on the bearing parts, shall not burn, so as to avoid high temperature melting metal, should be put in hot water or hot oil clean up after melting. (2) bearing installation, application boards bearing end face on the mat, reoccupy tongbang will gently dozen watts, the outer surface of the self-contained bearing and the bearing cover joint to close together, or bearing is easy to get, or alloy layer to crack or even fall off. In order to guarantee the close coordination of the bearing, the surface should be separately is a little taller than separate bearing surface ( As a general rule, be 0. 05 ~ 0. 1mm) 。 (3) bearing in the body, there is no axial or radial movement, generally adopts the positioning pin, convex key check mouth or steps to fix. Bearing assembly interface requirements in 70% ~ 75%. If you are interested in the above jiaxing bearing factory introduction of HRB bearing or have any questions, please click on contact us page on the right side of the online customer service, or call: 4006578186, jiaxing bearing retail center you full thoughtful procurement consultant. - - - - - - Editor: HRB bearing sourcing consultant LTD. All rights reserved, Jiaxing bearing factory) Reprint please indicate the source