Composite bearing removal methods

Composite bearing source of disassembly method: this site author: the administrator to release time: 2020 - 07 - 30 14:33:05 views: 1, the use of the bearing is very much, we on many products can be found that the influence of the bearing. With the use of product performance, as well as the different occasions, to be installed in the bearing quality requirements are also different, generally advanced equipment for bearing performance requirements would be more higher, so whether it's good quality or general quality of the bearing are also very widely used. Then we can take a combination of bearing manufacturers understand the combined bearing removal method. The removal of 1, peripheral. Remove the interference fit of the outer ring, whether in setting several outer shell on the circumference of a circle of extrusion screw with screws, remove one side equal to tighten the screw side. These cover usual blind plug, screw hole in the shell shoulders set several incisions, use block, remove by press, or tap the disassembly. 2, remove the inner ring. Can use pressure mechanical pull out, should pay attention to let the inner ring under the pulling force. By setting on the axis of hydraulic oil hole, in order to make easy to pull out. Width of the bearing is oil pressure method and drawing fixture and disassembly operations. 3, remove the combination of relatively small bearings, with fastening on the shaft gear support inner ring, the nuts back a few times, use the block with a hammer beating the disassembly. Because of many reasons we need to use a combination of dismounting bearing, its main purpose is to implement composite bearing more good use. But if we remove the way is not much, can have very large combination may cause bearing damage, so for people who often need to pick up the rough to the bearing, the proper removal methods of composite bearing is necessary. Composite bearing manufacturer which good, suggest you can consider our company's production of bearings, believe that we can satisfy the use of the masses of customers.