Clean install bearing need to pay attention to what aspects

1. When cleaning a lot of bearing, with the first temperature is 90 ~ 100 ℃ heat oil pour hot oil to make packaging condensation, at the same time with seamless all mouth and no net exfoliation tools to dig the old oil, then pour hot a few minutes, then rinse with kerosene oil, clean with gasoline again. After washing clean, the bearing on film gloves should be worn in the workbench of dry clean cloth or paper. 2. Before the high temperature bearing assembly, should use the appropriate measurement tools according to the technical request rules on the design drawings, check the shaft and hole and machining quality of parts ( Such as dimensional accuracy and shape accuracy and surface roughness, etc. ) 。 3. Encapsulated in the device when open bearing, put it into the liquids such as gasoline with handle gently gently turning, to ensure that insist on frame, rolling element and raceway appearance of encapsulated oil be cleaned completely. , 4. Assembly shall be appearance with a clean gasoline, kerosene, toluene and xylene solution clean, and to wipe them with clean cloth, and then coated with a thin layer of smooth oil, it can make the equipment operation more lunch. 5. Note with sealed bearing is clean with this law, sealed internal cleaning should stick to the same. 6. Shaft and bearing hole assembly if there is a dent on appearance, burr, rusty spot or solid particles ( Such as abrasive dust, sand, clay) Such as existence, not only can make the bearing assembly difficult position and make the device is not correct, and solid particles such as falling into a bearing inner grinding effect, when bearing rotating grinding or bruising bearing work appearance, so must be carefully checked before the unit, if found to have the above defects, should be revised. Applications such as oil file to remove burrs, bump touch mark, rusty spot, with fine abrasive cloth lighting, and like a clean solid particles, dirt, etc. A: high temperature bearing manufacturer for you to choose the high quality bearing next article: how to measure rolling bearing clearance - — For you to solve