Attaches great importance to the stainless steel bearing assembly

Stainless steel bearing assembly is a big problem, if the assembly is not reasonable, so will cause great losses. Therefore, we must be caused take seriously. We in the assembly of stainless steel bearing, not only reasonable steps to ensure that the assembly, at the same time should also pay attention to control the error size. In the process of assembly, there are many reasons can cause error is too large. Such as stainless steel bearing inner and outer circle not stay in the same center of rotation, shaft deflection problems appear. This question is also one of the more common problems in the process of actual use, and it's easy to cause bearing failure. In addition, the installation is not correct, a significant deviation, there is not even installed, thus caused the bearing clearance is too small. In stainless steel bearing during operation, the temperature of the shaft will be higher than the temperature of the outer ring, so the expansion will be larger, if the bearing clearance is too small, so it is easy to appear problems such as card dead. In addition, we in the stainless steel bearing assembly, you need to ensure that the use of suitable pre-tightening force. Otherwise, if too small, can cause bearing work appear larger gap; And if the pre-tightening force is too large, it will reduce its service life. When assembly using stainless steel bearing must be caused take seriously, such ability can ensure long service life of the stainless steel bearing. Quality of the production of stainless steel bearings, less problem, as long as the correct installation and maintenance, ensure that you get satisfaction, with fun! Welcome customers to inquire, the phone!