【 Agricultural machinery technology 】 Baling machine parts maintenance technology

【 Agricultural machinery technology 】 2019 - baling machine parts maintenance technology 08 - November 1, wheel bearings, wheel bearings should be remove, clean and reassemble a year. Use high quality wheel, grease the wheels in adjusting nut tighten the bearing at the same time. Loosen the adjusting nut until the groove of the adjusting nut and cotter pin holes on the shaft alignment, install the cotter pin. 2, power pivot regularly check power pivot spring, keep the spring length is 68 mm. 3, pickup drive belt pickup drive belt must be able to deliver enough torque to drive pickup, overload must be able to slip to protect pickup and transmission device. Belt can transfer torque is installed in the spring tension wheel arm's length. Everyday must keep the belt clean when using, shall not be stained with butter and oil. If the belt becomes dry, hard and started to crack, should replace a new one. 4, plunger removed plunger in order to inspect the bearing, slide block and the slide rail. After the plunger removed, a careful examination of bearing wear, flat spot, the problem such as untight seal or seized up, when it is necessary to replace. Check the wear condition of straw bale chamber slippery course, it would have produced by grinding or slider bearing out of the trench, to replace if necessary. In replacing slippery course, if it use gaskets pad, to ensure that when installing the gasket also put them back in place, to keep them straight slide rail.