Again, use the matters needing attention of KOYO bearing

Judgment standard according to the mechanical properties and important degree and inspection cycle. If you have the following injury, KOYO bearings shall not be used again, must be replaced. 一) Bearing parts of rupture and defects. b） The raceway surface material on the surface of the rolling strip. Bearing will be removed when check, use first method such as photography and then record the appearance. In addition, to confirm the amount of residual lubricant and lubricant sampling, and then clean the bearing. A, bearing cleaning divided into rough washing and fine washing, can be put in use at the bottom of the container and on the metal frame. B, rough washing, oil using a brush to remove grease or adhesive. If at this time in oil bearing, pay attention to the rolling surface due to foreign bodies such as damage. C, fine cleaning, slowly rotating bearings in the oil, must be carefully. Commonly used cleaning agent for neutral aqueous diesel or kerosene, according to the need to sometimes use warm lye, etc. No matter use which kinds of detergent, often should filter clean. After cleaning, coating anticorrosive oil or antirust grease on the bearing immediately. KOYO bearing is precision components, and its use should be measured accordingly. No matter how high performance bearing use, if use undeserved, will not get the desired performance. Use of bearing the note below. ( 1) And keep the bearing and the surrounding clean. Even the eyes can't see the little dust, will also bring bad influence to the bearing. So, keep the surrounding clean, dust from invading KOYO bearing. ( 2) , carefully use. In use for bearing strong impact, will produce scar and creasing, become the cause of the accident. Severe cases, can crack, fracture, so must pay attention to. ( 3) And use the appropriate operating tools. Avoid to existing tools to replace, must use the appropriate tools. ( 4) And to pay attention to the corrosion of the bearing. Operating KOYO bearing, hand sweat will become the cause of rust. Pay attention to the operation with clean hands, it is better to try to bring gloves.